Our Service

Flow Chart


Inquiry stage→ we need 3D and 2D part drawing, requested mold standards, mold cavities, and part material to quote our best price.


New project starts stagePO and latest drawing(2D and 3D) from customer. Then our engineer provide DFM based on the latest drawing. And we send our mold drawing to customer to double review after short communication on DFM with customer.


During mold makingafter customer release the mold drawing, we start to make mold. during mold making, we provide weekly mold processing report, including mold processing pictures to customer each week so that customer can also monitor the mold processing till the mold was finished.


Project finished stage

1. For exported mold, we will make sure the mold no problem for production after customer confirmed the mold delivery before we deliver the mold.

2. For regular production mold in our factory, we will maintain the mold after production.

3. For plastic parts production, our engineer will check the part dimension based on confirmation sample and drawing before mass production. We pack the parts based on customers’ requirements. If customer does not have any requirements, we will handle the packing based on the quality of the parts.


After sales stage, if there is any issue for parts or molds from customer, we will prove the issue with customer at the first time. If it is our fault, we will take responsibility. If it is not our fault, we will also support customer to solve the problem.



Engineering Ability


Dept.

Title

Level

Number

Working Life

Design Dept.

Mould Designer

Primary

2

>2 Years

Design Dept.

Mould Designer

Intermediate

8

>5 Years

Design Dept.

Mould Designer

Advanced

3

>10 Years

Project Dept.

Project Engineer

Intermediate

2

>6 Years

Project Dept.

Project Manager

Advanced

1

>15 Years



Our company has a complete set of personnel for design and project control. At present, there are 13 designers and 3 project control personnel. The specific configuration is shown in the table below




  Mold Flow Analysis




In many cases, there is a bottleneck in mold design and processing, that is, mold design and processing have been completed, but there are many problems in production. In order to make mold design more rational, our company usually helps customers carry out mold flow analysis, which can reduce the blindness in mold design and processing. The following is the picture of our mold flow analysis.



  Mould Design—2D




In the past, at the beginning of a project, we usually design 2D molds according to customer requirements. The following picture is an example of our 2D engineering drawings of a mold.



  Mould Design—3D



With 3 d software function of increasingly powerful, we can see any of the component directly on full 3D model.  This is a  great convenience for customer to audit the model.  and also convenient for us to communicate with customer directly. Below is the picture of the 3d Model from us.